![]() ![]() dev/nvme0n1p1Īccept erasing of the choosen partition with "Yes" If the last command does not list any file then something went wrong between 3.) and 5.)Ĭhoose option: "Boot from SPI - system on SATA, USB or NVMe"Ĭhoose NVMe partition, eg. Verify that the SPI mtd interface is enabled by running If you already have Radxa's u-boot written to SPI you need to short pins 23 and 25 for Armbian to bootīoot fresh image of Armbian v20.11.x for ROCK Pi 4(A/B/C)Īdd the following lines to /boot/armbianEnv.txtĭisconnect them after the ROCK Pi 4 fully boot'sĮcho spi1.0 > /sys/bus/spi/drivers/spi-nor/bind Prerequisities: ROCK Pi 4(A/B/C) v1.4 or 1.3 with SPI soldered in (v1.3 comes without SPI flash from the factory). Spl/u-boot-spl.bin with a GP image header prepended to it.Ĭontains u-boot.bin along with an additional header to be used by the boot ROM to determine how and where to load and execute U-Boot.With Armbian v20.11 one can write mainline u-boot image to board's SPI and enjoy booting nvme drives without any mmc devices. The second-stage bootloader (a stripped down version of u-boot that fits in SRAM).Ĭontains the information for each symbol. If an error is detected, the host is requested to re-transmit the packet again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |